PFA-100 Closure Time - Whole Blood

When a project requires PFA-100 Closure Time, the important question is not only whether a laboratory can produce a number, but whether the result truly represents Whole Blood. This test addresses the requested biomarker or biological characteristic in the submitted specimen and is commonly relevant to blood-cell, haemostasis and coagulation assessment for clinical investigation and monitoring. A representative sample, appropriate controls and a method suited to the matrix are therefore central to the service. A typical technical approach is Validated laboratory method appropriate to the measurand, matrix and applicable standard. The exact instrument, standard, extraction, digestion, calibration model, culture condition, reagent system or specimen-processing step may differ according to the receiving laboratory's validated scope. Where an ASTM, ISO, IEC, EPA, FDA, pharmacopeial, clinical, customer or in-house method is mandatory, that requirement should be stated when the test is booked. The laboratory should also confirm that its working range, selectivity, detection capability and quality-control scheme are appropriate for the expected level of PFA-100 Closure Time. Results produced outside a validated range may require dilution, repeat preparation, a different specimen quantity or a more sensitive method. Sample quality is especially important. Submit approximately 2–4 mL of Whole blood, unless the laboratory specifies a different minimum after reviewing the method. The sample should represent the batch, location, patient, product, process stream or experimental condition that the customer actually wants to evaluate. Where the material is heterogeneous, replicate increments or a documented composite may be more defensible than a single convenient grab sample. Contamination, evaporation, moisture change, degradation, microbial growth, inappropriate anticoagulant, adsorption to the container, or alteration during transport can create a result that is analytically precise but not representative of the original material. The final report should identify the sample, method or method family, result, units and any relevant reporting or quantification limit. For compliance work, the customer should provide the applicable specification so the laboratory can avoid making an unsupported pass/fail judgement. For research work, raw or supporting data may also be useful for statistical analysis, comparison across treatments or publication. For this exact catalogue entry, identify the request as “PFA-100 Closure Time” and the matrix as “Whole Blood”. If the project involves multiple samples, keep the naming scheme consistent so the result for one specimen cannot be confused with another. Tell the laboratory about known interferents, treatments, formulation ingredients, service history or unusual sample conditions that could affect Validated laboratory method appropriate to the measurand, matrix and applicable standard. The AnalysisAfrica listing should be used to arrange the test and sample logistics; the receiving laboratory remains responsible for confirming the final analytical procedure, sample acceptance and reportable scope. Catalogue quality-control reference AA-DESC-04898 distinguishes this description and its handling assumptions from other tests in the import set.